Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/201648
5.4.1 Sewing process
Start the sewing process as follows:
1. Push the pedal forwards and sew.
Th
e following appears on the display:
Fig. 20: Sewing process (1)
The parameter values for the current step are shown on the
display.
The program bar (1) shows the progress of the seam.
The number under the current step (3) shows the outstanding
length of the step.
The program bar shows half the current step in bold.
Fig. 21: Sewing process (2), current step
Completed steps are shown fully in bold.
Fig. 22: Sewing process (3), completed step
(1) - Program bar (2) - Current step
To Next Page
Loading...
