Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016 53
Depending on the settings at the technician level
• The sleeve side that was created is mirrored
• The sleeve side that was created is not mirrored
• The teach-in for the 2
nd
sleeve side is opened
• The selection screen for the action of creating the
2
nd
sleeve side is opened
The controller switches to Automatic mode.
The sewing program that was just created is activated.
Fig. 26: Creating a program by keyboard input
5.5.2 Creating a program by sewing the seam
Information
Before the S key is pressed, program creation can be canceled
at any time by pressing the ESC key.
If a section of seam has already been sewn the sewing program
will have been saved and must if necessary be deleted, ( p. 60).
1. Insert the sewing material.
2. Input the parameters for the 1
st
step (fullness, stitch length,
thread tension and curve support).
3. Sew the first step.
4. Operate the knee lever.
Th
e controller switches to the next step.
Once all steps are complete:
5. Press the S key
.
Th
e sewing program is saved.
The following appears on the display:
To Next Page
Loading...
