Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016 59
8. Press the corresponding key to select if
• the sleeve side that was programmed should be mirrored
•
the sleeve side that was programmed should not be
mirrored
• the teach-in for the 2
nd
sleeve side should be opened
5.6.3 Copying the sewing program
The selected sewing program is copied into a new program
number.
Proceed as follows to copy an existing sewing program:
1. Press the key.
The softkey menu appears on the display:
Fig. 35: Copying the sewing program (1)
2. Press the key.
The display shows the next available program number:
Fig. 36: Copying the sewing program (2)
3. Press OK to load the program number.
OR:
To Next Page
Loading...
