Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/201658
Fig. 32: Creating a new sewing program (3)
4. If necessary change the sleeve side or other parameters
( p. 54).
5. Press the key.
The display shows the following information,
the P i
n the program number field flashes:
Fig. 33: Creating a new sewing program (4)
The rest of the procedure is described in the chapter Easy
mode ( p. 50).
6. Select whether progression to the individual steps to be pro-
grammed should be by using the knee lever or by automatic
prog
ression.
7. Press the key.
Once the creation of the program is complete and the S key
has
been pressed or after the thread cutoff has been entered, the
following selection window appears:
Fig. 34: Creating a new sewing program (5)
To Next Page
Loading...
