DURKOPP ADLER 650-10 - Creating a Program by Keyboard Input

Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/201652
5.5.1 Creating a program by keyboard input
Information
Before the S key is pressed, program creation can be canceled
at any time by pressing the ESC key.
1. Set all the parameters for each step.
2. Operate the knee lever.
 Th
e controller switches to the next step.
Once all steps are complete:
3. Press the S key
.
 Th
e sewing program is saved.
Stitch length
Value range: 1.0 – 4.0 mm
•Use
/ to select the parameter
•Use
/ to change the stitch length
Thread tension
Value range: 1 – 99
•Use
/ to select the parameter
•Use
/ to change the thread tension
Curve support
Value range: 0 – 6
•Use
/ to select the parameter
•Use
/ to change the curve support
Length of the current step in mm
Symbol Meaning