Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016 51
Select another program number using / or input a pro-
gram number using the keypad keys 0 – 9 and then press
the OK key.
The display shows the following information,
the P i
n the program number field flashes:
Fig. 25: Easy mode (3)
The following table shows the individual symbols on the display
and the functions of the keys on the control panel.
Symbol Meaning
Automatic step progression on or off
• Press the upper softkey
Current sewing program to be created
Current sleeve side to be created
(pre-set at the technician level)
Current step
•Use
/ to select the parameter
•Use
/to switch to the next/previous step
• Press the OK key to edit other parameters for the
step, Edit mode ( p. 54)
Fullness
Value range: Upper fullness: 0 – 16
Lower fullness: 0 – 6
• Use the numeric keys 0 – 16 to select the desired
fullness.
• Use the plus/minus key to select upper or lower
fullness.
OR:
• Use the additional pedal to select the fullness, if fitted
To Next Page
Loading...
