Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/201686
Left pane (2)
The graphical representation of the entire seam, divided into the
number of programmed sewing steps, is displayed here.
Middle pane (3)
Existing sewing programs can be edited here ( p. 86).
The number and the name of the selected sewing program are
displayed, together with the symbols for all the parameters that
can be set. The gray fields above the parameter symbols show
the respective current values.
Right pane (4)
Here, sewing programs can be created ( p. 92), deleted
( p. 101), copied ( p. 101) and optimized ( p. 102).
6.5.1 Parameters that can be set
The following table lists the parameters that can be set in EDIT
operating mode.
Symbol/button Meaning
Changing the program name
There is only one display in EDIT operating
mode. A new sewing program is automati-
cally assigned the next free program slot.
Select the right or left piece to be sewn
Set the sewing material size, p. 88
Other program parameters in operating
mode EDIT, p. 90
To Next Page
Loading...
