Setup
Operating Instructions 650-10 - 03.0 - 08/2016128
8.9.2 Connecting the setpoint device to the controller
Fig. 86: Connecting the setpoint device to the controller
Connect the setpoint device to the controller as follows:
1. Connect the setpoint device for the main pedal to
conn
ector X5b .
2. If present, connect the setpoint device of the additional pedal
to connector X440; the cable hangs freely in the cable har-
ness.
8.9.3 Establishing equipotential bonding
Important
Before putting the machine into operation, you must establish
e
quipotential bonding in all necessary places.
Establish equipotential bonding as follows:
1. Establish equipotential bonding as specified in the wiring
diagram ( p
. 161).
(1) - Setpoint device for main pedal
To Next Page
Loading...
