Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/201644
Assign a function to the upper softkey as follows:
1. Press the numeric key under the desired function
and the upper softkey at the same time.
Th
e function is assigned to the upper softkey
and can be called up by pressing the key.
5.3.2 Menu for other settings
1. Use / to select the field .
2. Press the OK key.
3. Use / to
select the desired parameter.
4. Press the OK k
ey to select the parameter.
5. Change values using the / keys.
6. Press the OK k
ey to confirm.
7. Press or ESC to exi
t the menu.
Symbol Meaning
Alternate (sewing foot alternation)
Value range: 0.0 – 2.5 mm
Foot Press. (sewing foot pressure)
Value range: 1 – 10
Start Tack (bartack at seam beginning)
Value range: 1 (= on) or 0 (= off)
End Tack (bartack at seam end)
Value range: 1 (= on) or 0 (= off)
Thread Trim (thread cutter)
Value range: 1 (= on) or 0 (= off)
To Next Page
Loading...
