DURKOPP ADLER 650-10 - Sewing Process in Automatic Mode

Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/201684
6.4.2 Sewing process
1. Select a sewing program ( p. 79).
 Th
e program number and name of the sewing program are
displayed on the user interface. If no name has been saved
for the selected sewing program, <No Name> is displ
ayed.
2. Select the right or left piece to be sewn by tapping .
3. Select sewing material size ( p. 80).
4. Push the pedal forwards and sew the seam.
 Th
e sewing progress is displayed graphically in the left pane
as a red bar.
Fig. 53: Sewing process
 The remaining sewing length per sewing step is displayed:
Correcting the fullness before or during the seam
1. Press Pedal to position 0.
2. Change the fullness correction using the buttons + F% or - F%.
3. Push the pedal forwards and sew.
 Th
e changed fullness value is applied and displayed.