Service settings via software (OP3000)
Operating Instructions 650-10 - 03.0 - 08/2016 57
5. Exit the submenu using ESC or .
You can exit Edit mode with a press of the ESC key.
5.6.2 Creating a new sewing program
1. In Edit mode, press the key.
Th
e softkey menu appears on the display:
Fig. 30: Creating a new sewing program (1)
2. Press the key.
Th
e display shows the next available program number:
Fig. 31: Creating a new sewing program (2)
3. Press OK to load the program number.
OR:
Sele
ct another program number using
/ or input a
program number using the keypad keys 0 – 9 and then
press the OK key.
Th
e program number is loaded.
The display shows the following information,
the P i
n the program number field flashes:
To Next Page
Loading...
