Operation
Operating Instructions 650-10 - 03.0 - 08/2016 31
4.7.3 Setting the needle thread regulator
The needle thread regulator regulates the amount of needle thread
required for forming the stitch. An optimum sewing result is pos-
sible only when the needle thread regulator is exactly adjusted.
Proper setting
With the proper setting the needle thread loop must slide over the
thi
ckest part of the hook at low tension.
When the largest thread quantity is requi
red then the thread
tension spring (3) must be pulled approx. 0.5 mm down from its
upper end position. This occurs when the needle thread loop
matches the maximum hook diameter.
Fig. 12: Setting the needle thread regulator
To set the needle thread regulator:
1. Loosen the screw (1).
2
. Change the setting of the needle thread regulator (2).
3. Tighten the screw (1).
(1) - Screw
(2) - Needle thread regulator
(3) - Thread tensioning spring
To Next Page
Loading...
