Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/2016 73
MAN mode Setting the fullness
The following table lists the symbols and buttons for manually
setting the fullness.
To set the fullness:
1. Select the type of fullness.
Th
e type of fullness selected is displayed in an activated
control field within the symbol.
2. If a higher or lower degree of
fullness is required, use the
arrow keys to display more buttons.
3. Input the fullness using the buttons 0 to 16.
Symbol/button Meaning
Inputting the fullness.
The fullness setting is displayed by a but-
ton highlighted in red.
Select the type of fullness:
• Upper (upper transport)
• Lower (lower transport)
The fullness selected is displayed in an
activated control field.
Display of further buttons for inputting the
fullness. The buttons 0 to 16 are available
for input.
To Next Page
Loading...
