Settings via software (OP7000)
Operating Instructions 650-10 - 03.0 - 08/201674
Setting the curve support
The following table lists the symbols and buttons for manually
setting the curve support.
The default setting is a value of 2.
To set the curve support:
1. Input the curve support using the buttons 0 to 6.
MAN mode Other program parameters
A tap on the Other program parameters button will bring up an
overview of all available parameters.
Fig. 46: Other program parameters
Symbol/button Meaning
Inputting the curve support.
The curve support is displayed by a button
highlighted in red.
To Next Page
Loading...
