DURKOPP ADLER 650-10 - Page 142

Troubleshooting
Operating Instructions 650-10 - 03.0 - 08/2016140
1055 Error Sewing motor overload (I²T):
• Sewing motor not moving
fr
eely or blocked
• Sewing motor defective
• Controller defective
• Remove the cause of the
stif
f movement or blockage
• Replace the sewing motor
• Replace the control
1056 Error Sewing motor
overtemper
ature:
• Sewing motor not moving
fr
eely
• Sewing motor defective
• Controller defective
• Correct the cause of not
moving fr
eely
• Replace the sewing motor
• Replace the control
1058 Error Sewing motor speed greater
than setpoint:
• Reference switch defective
• Sewing motor defective
• Replace the reference
swi
tch
• Replace the sewing motor
1060 Error PowerParts • Replace the control
1061 Error Sewing motor disturbance:
• Encoder defective
• Sewing motor defective
• Switch the machine off and
on again
• Replace the encoder
• Replace the sewing motor
• Contact customer service
1062 Error Sewing motor disturbance
(IDMA au
to increment)
• Switch the machine off and
on again
1120 Error Software error:
• Parameter not initialized
• Perform a software update
1203 Information Sewing motor:
Position not reached
• Switch the machine off and
on again
• Perform a software update
• Contact customer service
1302 Error Sewing motor current error:
• Sewing motor blocked
• Encoder cable not
connected or defective
• Encoder defective
• Remove the blockage
• Check the encoder cable
and rep
lace, if necessary
• Replace the sewing motor
1330 Error Sewing motor not responding • Switch the machine off and
on again
• Perform a software update
• Contact customer service
Code Type Possible causes Remedial action