About these instructions
Operating Instructions 650-10 - 03.0 - 08/20166
Cover
Specifies which covers have to be removed in order to access the
co
mponents to be set.
Steps to be performed when operating the machine
(sewing and equipping)
Steps to be performed for service, maintenance, and
in
stallation
Steps to be performed via the software control panel
The individual steps are numbered:
1. First step
2. Second step
The steps must always be followed in the specified order.
Lists are marked by bullet points.
Result of performing an operation
Change on the machine or on the display/control panel.
Important
Special attention must be paid to
this point when performing a step.
Information
Additional information, e.g. on alternative operating options.
Order
Specifies the work to be performed before or after a setting.
References
Reference to another section in these instructions.
To Next Page
Loading...
