ECKELMANN E-Control CNC - Terminating Controller Communication

89 / 97
Introduction Manual ENC66
eckelmann.de
• The boot project can be cleared again with „Online – Reset (origin)“
If the firmware and the PLC program were loaded via the StdHMI into the controller, the
PLC program isn‘t stored in the controller. Only the file that was loaded via the StdHMI is
replaced on the harddisk.
10.11.8 Termination of communication with the controller
• Upon login to the controller with „Online – Login“ the controller can be exited with
„Online – Logout“
The program in the controller maintains the status last selected.