5 / 97
Introduction Manual ENC66
eckelmann.de
Table of Contents
1 Overview.............................................................................. 12
1.1 List of documents................................................................................................. 12
1.2 Controller family E-CONTROL CNC ..................................................................... 13
1.3 Variants „Stand-Alone“ and „With PC-HMI“..................................................... 14
1.4 Status information of the ExC66......................................................................... 15
1.4.1 Status information during booting .................................................................... 15
1.4.2 LEDs while booting .............................................................................................. 16
1.4.3 Status information during start of firmware ..................................................... 17
1.4.4 Status information in normal operation ............................................................ 18
1.4.5 The LEDs in normal operation............................................................................. 19
1.4.6 Error indication .................................................................................................... 20
1.4.6.1 Error indication during booting.......................................................................... 20
1.4.6.2 Error indication in normal operation ................................................................. 20
2 Connection and installation............................................... 22
2.1 Example of a structure......................................................................................... 22
2.2 Controller connection.......................................................................................... 22
2.3 Serial connection.................................................................................................. 24
2.4 Connection via Ethernet...................................................................................... 24
2.4.1 Connection via Ethernet (local connection) ....................................................... 25
2.4.2 Connection via Ethernet (network) .................................................................... 25
3 Monitor interface of the controller................................... 26
3.1 Running the terminal program........................................................................... 26
3.1.1 Configuration of the terminal program............................................................. 26
3.2 Calling of the monitor interface......................................................................... 28
3.3 Configuration of an Ethernet connection.......................................................... 30
3.4 Important monitor commands............................................................................ 32
3.5 Possible errors ...................................................................................................... 33
4 Setting of the IP address in the controller........................ 34
4.1 Setting of the IP address via the monitor interface (serial interface) .............. 34
4.2 Setting of the IP address via Ethernet (network or local) with NetConf.......... 35
4.2.1 Automatically display controllers in NetConf .................................................... 35
4.2.2 Change the IP address of a controller with NetConf......................................... 36
4.2.3 Configure gateway and subnet mask in NetConf.............................................. 37
4.2.4 Add a controller in NetConf manually ............................................................... 37
To Next Page
Loading...