Parameter List and Menu Structure of VS 300
115
Doku-Version 2.05 - Firmware 2.10 - 15. September 2017
8.2 Overview of alarm types
The following alarms are recorded by the VS 300 and saved to report memory:
S System fault reports
S Process fault reports
Parameter
No.
System fault reports
E000 Internal fault
E004 EEPROM parameter memory defective/not responding
E005 Defective EEPROM contents (checksum)
E008 Internal clock defective
E009 Internal bus system fault
E010 Internal battery low
E050 First start loading default parameters
E051 Restart after power failure
Process fault reports
E180 Service mode active
E181 Fast unload active in Control Loop #
E182 Load shedding active in Control Loop # active
E203 Pressure sensor parameter changed
E207 High pressure in Control Loop 1; (LT1, NT1 or HP1)
E208 High pressure in Control Loop 2; (LT2, NT2 or HP2)
E209 Low pressure CL1
E210 Low pressure CL2
E211 Pressure sensor measuring loop error CL1
E212 Pressure sensor measuring loop error CL2
E222 No Load Level in Control loop 1
E223 No Load Level in Control loop 2
E224 No UA 300 found with refrigeration point control
E240 Setpoint changed
E241 Controller configuration changed
E243 Digital input 1 active
E244 Digital input 2 active
E245 Digital input 3 active
E246 Digital input 4 active
To Next Page
Loading...
