STP-iXA3306 Series Turbomolecular Pump
4.6.2 Starting/stopping the STP pump
There are two methods for the starting/stopping operation with the parallel port.
Use one of them.
1. Contact input
Open the circuit between (19)–(37).
1) Short the circuit between (1)-(21).
2) Short the circuit between (3)-(21) for 0.3
seconds or more.
However, when inputting this signal
simultaneously with switching "ON" the STP
pump, short the circuit between (3)-(21) for 10
seconds or more.
Open the circuit between (1)-(21).
Short the circuit between (1)-(3).
In this case, (21) is not used.
Open the circuit between (1)-(3).
Table 14 - Starting/stopping the STP pump using contact input (X2 REMOTE)
Figure 31 - Pump operation method 1 (contact input)
Figure 32 - Pump operation method 2 (contact input)