EFI Fiery ES IC-418 - Manage Print Jobs with Email Commands; Printing from a USB Flash Drive

6
Send the email.
The file is sent to the Fiery ES and the job is printed. After the Fiery ES receives the job, you receive an email
notification that the print job was accepted. The email provides a job identification (ID). Use job IDs to manage
jobs with email commands. The email notification indicates any current error at the printer. (See Manage print
jobs with email commands on page 53.)
After the job is printed, you receive a second email notification that indicates the job printed successfully.
Manage print jobs with email commands
You can manage your print jobs by submitting commands to the Fiery ES using email.
You can cancel a job, check job status, and get help on a job. When you send a command, the Fiery ES sends an email
response.
1 In your email application, type the Fiery ES email address in the To: line.
2 Type one of the following commands in the Subject line:
• To check the status of a job, type #JobStatus<job id> in the Subject line.
You receive a reply to your job status query. You can only get the status of the job if you sent the job or are an
administrator.
• To cancel a job, type #CancelJob<job id> in the Subject line.
You receive a notification indicating that the job has been canceled and did not print to the Fiery ES. You can
only cancel a job if you sent the job.
• To get help, type #Help in the Subject line.
You receive an email response that contains links that allow you to cancel jobs, check job status, and search
and manage address books. Click any of the links to perform a command.
3
Send the email to the Fiery ES.
Printing from a USB flash drive
You can print files from a USB flash drive to the Fiery ES. The Fiery ES supports printing from the USB flash drive
using USB Media Server.
The USB port and automatic printing feature must be enabled in Configure, as described in Configuration and Setup
or Command WorkStation Help.
You can manually print files from a USB flash drive when USB Media Autoprint is disabled in Configure.
Files are automatically processed as soon as you connect the USB flash drive to the Fiery ES. The files can be from
Mac OS or Windows computers, and can be any of the supported file types (DOC, EPS, PCL, PDF, PPT, PS, TIFF, or
XLS).
Note: The Enable Native Document Conversion Using PrintMe option in Configure must be turned on to print DOC,
PPT, and XLS files.
Printing
Other Printing Methods
53