•
Front cover and Back cover: These options allow you to quickly decide whether your front and back covers print
duplex, single-sided, or both sides blank, without needing to add blank pages in your original document.
With top-edge binding that includes a cover, the outside of the back cover automatically rotates 180 degrees to
match the orientation of the front cover.
•
Define Cover: This option allows you to select cover media settings for your cover pages, which may be trimmed.
This option is available for both pre-printed and inline covers.
Printing Booklet Maker jobs
Booklet Maker does not support jobs sent to the Direct connection. Booklet Maker print jobs must be sent to the
Print queue or Hold queue.
Set measurement units in Command WorkStation
You can change the default unit of measurement for all input fields in the Command WorkStation Preferences
window.
Units specifies the units of measurement used to display attributes, such as page sizes and custom sizes, that you
enter in the Job Properties window. This setting does not affect predefined page-size values.
1 In Command WorkStation, select Edit > Preferences.
2 Click Region to access Regional Settings.
3
Select the unit of measurement (millimeters, points, or inches).
4 Click OK.
The changes are not effective until Command WorkStation is restarted.
Defining and printing custom page sizes
With custom page sizes, you define the dimensions of a printed page. After you define a custom page size, you can
use it from within an application without redefining it each time you print.
When you create custom page sizes, specify width dimensions to correspond with the shorter side of your job and
specify height dimensions to correspond with the longer side of your job. Set custom page sizes in this way,
regardless of the orientation settings in the application.
Printing
Print Options
98
To Next Page
Loading...
