ImageViewer
ImageViewer allows you to adjust colors in a job before it is printed. You can also use the preview in ImageViewer to
verify job placement, orientation, and content, as well as general color accuracy.
You can choose to display the plate data for each process color independently or in combination with the other
colors, allowing inspection of individual plate data or a combination of any range of plates.
You can inspect the color values at specific places on a page, allowing you to soft proof the color output.
If the job contains halftone simulation settings, the preview shows a composite view of all separations at the dot
level.
For information about using ImageViewer, see Command WorkStation Help.
Access ImageViewer
Start ImageViewer from the Actions menu or Preview window of Command WorkStation.
Access ImageViewer from Actions menu
1
In Job Center in Command WorkStation, select the job that you want to preview.
Note: ImageViewer recognizes only jobs that show processed/held (dark yellow) status. Processed/held jobs are
also indicated by the raster job icon (page with blue arrow).
2 If needed, select Actions > Process and Hold to move the job to processed/held status.
3
To start ImageViewer, do one of the following:
• Select Actions > ImageViewer.
• Right-click the selected job and select ImageViewer from the menu that appears.
Access ImageViewer from Preview
1
In Job Center in Command WorkStation, select the job that you want to preview.
Note: ImageViewer recognizes only jobs that show processed/held (dark yellow) status.
2 If needed, select Actions > Process and Hold to move the job to processed/held status.
Fiery Productivity Package
ImageViewer
13
To Next Page
Loading...
