EFI Fiery ES IC-418 - Setup Options on the Printer Control Panel

Align Tray Use to adjust the placement of text and images on a page so that they are
correctly aligned on the sheet of paper, and to ensure that both sides of a
duplex sheet have the exact same alignment. For more information about
this function, see Command WorkStation Help.
Setup Use to select settings for the Fiery ES, including network settings and the
timeout period for the login to the printer control panel.
Restart Server Use to reboot, restart, and shut down the Fiery ES .
Clear Server Use to delete all jobs on the Fiery ES. User needs to confirm before
proceeding.
Info tab
You can use this tab to view information about the Fiery ES:
Server Name
The name assigned to the Fiery ES.
IP Address
The Fiery ES IP address.
Memory
The memory allocated to the Fiery ES.
Hard Drive
The size of the Fiery ES hard drive and the available free space.
Version
The Fiery ES operating system version.
User
The type of user account in the current session.
Installed Options
The software options installed on the Fiery ES.
Setup options on the printer control panel
You can configure the network settings for the Fiery ES through the Tools > Setup feature on the printer control
panel.
Before configuring the network information, confirm that the Fiery ES is connected to an active network. This allows
the Fiery ES to query the network for zones, servers, and server-based queues. If you perform Network Setup without
a connected and functioning network, default settings are used that might not be accurate for your network.
Configure options only for the network systems that are currently used at your site. If your network requirements
change, you can change Setup at any time. If the Fiery ES is configured to enable more than one protocol, it
automatically switches to the correct protocol when it receives a print job.
Important: The submenus and options in this topic appear in sequence.
Server Name
Sets the name of the Fiery ES on the network (15 characters maximum).
Note: If you set up more than one Fiery ES, do not assign them the same name.
Configuration and Setup
Setting up from the printer control panel
14