Enable 802.1x Authentication
Select to allow the Fiery ES to seek authentication from an 802.1x authentication server.
Select EAP Type
Choose the type of EAP (Extensible Authentication Protocol).
Note: This option is only available when Enable 802.1x Authentication is selected.
Validate Server Certificate
Select this option if you set Select EAP Type to PEAP-MSCHAPv2 and want the Fiery ES to use a trusted root
certificate when communicating with the authentication server. If you want the Fiery ES to validate the server
certificate, place the certificate in the list of trusted certificates of the Fiery ES.
Note: This option is only available when Enable 802.1x Authentication on page 16 is selected.
Username
The Fiery ES uses this information to request authentication from an 802.1x authentication server.
Note: This option is only available when Enable 802.1x Authentication is selected.
Use ASCII code characters (63 characters maximum). It is possible to enter more, but the supported length is 63
characters maximum. Although you can enter characters other than ASCII code characters, only ASCII code
characters are guaranteed for authentication.
Password
The Fiery ES uses this information to request authentication from an 802.1x authentication server.
Note: This option is only available when Enable 802.1x Authentication on page 16 is selected.
Use ASCII code characters (63 characters maximum). It is possible to enter more, but the supported length is 63
characters maximum. Although you can enter characters other than ASCII code characters, only ASCII code
characters are guaranteed for authentication.
Obtain IP for Engine
Select to allow the Fiery ES to obtain an IP address for the printer.
•
Select if the printer is connected to the network through the Fiery ES.
•
Clear to allow the printer to obtain its own IP address, which is possible if the printer is connected directly to the
network by a separate network cable.
Configuration and Setup
Setting up from the printer control panel
16
To Next Page
Loading...
