Image shift
The Image shift print option check box, when selected, adjusts an image for duplex printing by shifting the image
horizontally, in the direction of paper travel, relative to the leading edge.
This option affects the offsetting of the image for the entire job, not on a per-page-basis. However, you can specify
alignment settings for the front (odd) and back (even) pages.
Image Shift settings are not available from inside Mixed Media.
Image Shift is not supported for Booklet Maker and Gang-up printing.
For more information, see printer driver help.
Punch: Punch edge
The Punch edge print option allows you to specify the location of punched holes.
To use this option, you must install a finisher with hole punching functionality.
For information about installing finishers and other installable options, see printer driver help.
Punch: Punch holes
The Punch holes print option allows you to specify the number of holes to punch for your job.
To use this option, you must install a finisher with hole punching functionality.
For information about installing finishers and other installable options, see printer driver help.
For more information, see Punch position and hole punching on page 103.
Stapler: Staple
The Staple print option allows you to specify the number of staples and their positions.
Staple positions vary according to paper size, paper type, number of pages, and feed direction.
To use this option, you must install a finisher with stapling functionality.
Variable Data Printing (VDP) options
The VDP tab shows all Variable Data Printing (VDP) settings, such as FreeForm and advanced VDP settings.
The Fiery ES is compatible with the following variable data printing languages:
•
FreeForm and FreeForm 2
For more information about VDP languages, see Variable Data Printing.
VDP documents using FreeForm must have the following settings for the master document and variable document
match:
•
Color mode
•
Combine separations
Printing
Print Options
87
To Next Page
Loading...
