Installing user software
You can install Fiery ES user software on Windows and Mac OS computers.
Install user software:
•
From the User Software DVD
•
From the Fiery ES, using the Internet or intranet
Note: Fiery JobFlow is supported on Windows computers only.
If earlier versions of Fiery ES user software are installed on your computer, the installer allows you to uninstall those
applications before installing new software.
Note: When you upgrade user software, use the Fiery User Software Installer and follow the instructions by selecting
Modify.
For more information, see Modify user software from media on page 8.
If you do want to uninstall an earlier version of user software, you may want to back up your settings. Back up and
restore of Fiery ES resources and settings is available from Command WorkStation. For more information, see
Configuration and Setup and Command WorkStation Help.
After first-time installation of Fiery ES user software, updates are managed by the Fiery Software Manager
application. For information, see Using Fiery Software Manager on page 10.
Note: Before installing Fiery ES user software, you must disconnect any measurement instrument from the
computer. Otherwise, after installation the instrument may not be recognized by the software.
Installing user software on a Windows computer
Before installing the software, ensure that your computer meets the minimum system requirements. For system
requirements, see Configuration and Setup.
The only applications that are not installed by the Fiery User Software Installer are Adobe Acrobat and Enfocus
PitStop, for use with Fiery Impose/JobMaster/Compose. For more information, see Fiery make-ready applications on
page 20.
Procedures describe installing from the User Software DVD, or over the Internet, and also modifying the user
software.
Install user software on a Windows computer from media
1
Insert the User Software DVD into the DVD drive of your computer.
Utilities
Installing user software
7
To Next Page
Loading...
