EFI Fiery ES IC-418 - Internet Protocol (IP) Requirements; Client Computer Requirements; Installing and Configuring Printer Drivers

•
LPD
•
LPR
•
NetBios over TCP/IP (NBT)
•
POP3
•
Port 9100
•
SMB
•
SMTP
•
SNMP
•
SNTP
•
SSL/TLS
•
WSD
AppleTalk (supported for font downloads only)
Enabling this setting allows Mac client computers to use AppleTalk to download fonts to the Fiery ES.
Internet Protocol (IP) requirements
The Fiery ES requires the following:
•
Unique IP address (IPv4 or IPv6)
•
Subnet mask
•
Gateway address
You can enter these items manually or use DHCP protocol to assign them dynamically. Make sure the Fiery ES name
and address are listed in the domain name server (DNS) or host name database used by your system.
Client computer requirements
The Fiery ES utilities software, printer drivers, and online help are supported for Windows and Mac client
computers.
Installing and configuring printer drivers
Before you can print from a client computer to the Fiery ES, you must first install a printer driver on each client
computer and then configure them to include Fiery ES and printer installed options.
After you install and configure printer drivers, you can print from any application on a client computer to the Fiery
ES.
For more information about installing printer drivers, including installing printer drivers on other operating systems,
see Printing, which is part of the user documentation set.
Configuration and Setup
System requirements
8