EFI Fiery ES IC-418 - General Precautions for Working with the Fiery es; Fiery es Hardware

The following documentation resources are available for the Fiery
®
ES IC-418.
Resource Description
User documentation Documents in this set: Color Printing, Configuration and Setup, Fiery Productivity Package,
Printing, Utilities
Online help
•
Help can be accessed directly from each Fiery application or by going to help.efi.com.
•
Each help system is available as a printable PDF, accessed from the PDF icon in the upper right
corner of the Help window.
Additional reference
material
•
Fiery Color Reference - help.efi.com/ref/colorref/en-us/
•
Variable Data Printing - help.efi.com/ref/vdp/en-us/
•
Workflow Examples - help.efi.com/ref/workflows/en-us/
•
Configure Help - help.efi.com/configure/3.0/en-us/
General precautions for working with the Fiery ES
Fiery ES hardware
Always observe the following precautions to assist with personnel safety and prevent data loss or equipment damage.
Warning: Do not store or use flammable sprays or solvents near the Fiery ES or the printer. Components
within these machines can operate at a high enough temperature to provide an ignition source. Storing or using
flammable items near these machines could cause the items to catch fire or explode.
Warning: Never set any liquid on or near the Fiery ES or the printer. Spilling liquids into either machine could
result in electric shock and damage the machine. If liquid is spilled on or underneath either machine, or any
object falls into either machine, disconnect the corresponding power cable immediately, if safe to do so.
Warning: Do not remove the covers or otherwise open the Fiery ES hardware. Cables and parts inside the
chassis are intended to be serviced by technical support only.
Warning: Ensure that the power cabling remains as configured by the service technician. The designated power
cable and a grounded, correctly rated outlet must be used. If required, the cable should be protected by a surge
suppressor, line conditioner, or uninterruptible power supply (UPS).
Warning: Do not allow the power cords or cables to be compressed or bent at a sharp angle. Arrange them so
that no one might accidentally step on or trip over them.
Caution: Do not block the vents on the Fiery ES or otherwise restrict airflow. Leave clearance around all vents
and ensure that nothing falls into the vents.
Caution: Do not make mechanical modifications to the system. The safety and regulatory compliance of
modified equipment cannot be guaranteed.
Configuration and Setup
Introduction
6