EFI Fiery ES IC-418 - Set up Standard TCP;IP Port (Raw or LPR) Printing Connections on Windows Client Computers

•
IPP or IPP over SSL
•
FTP
•
WSD
Set up Standard TCP/IP Port (Raw or LPR) printing connections on Windows client
computers
After you install the printer driver, you can add or configure the Setup for the Standard TCP/IP Port (Raw or LPR)
connection on a Windows client computer.
To complete the Standard TCP/IP Port (Raw or LPR) connection, do the following:
•
Prepare the Fiery ES to accept print jobs using Standard TCP/IP Port (Raw or LPR) protocols.
•
Turn on LPD or Port 9100 on the Fiery ES.
•
Configure the computer for the TCP/IP connection.
For more information about Setup, see Command WorkStation Help.
Before you complete the following procedure, contact your administrator for the IP address assigned to the Fiery ES.
The TCP/IP protocol should be installed as a default on the Windows computer. For Port 9100, you can set up the
connection and install the printer driver in one procedure.
Note: You can also set up the LPR Port connection by installing Print Services for UNIX, which is supplied as an
add-on Windows component. For more information, see the documentation that accompanies Windows.
1
Navigate to the devices and printers on your network.
The printers are displayed in the Devices and Printers (or Printers and Faxes or Printers) folder.
2 Right-click the Fiery ES icon and choose Printer properties or Properties.
Printing
Windows for Fiery ES
18