PrintMe cloud printing
Users with a PrintMe subscription can upload a document to the PrintMe Cloud Service and then print the
document to the printer using the printer control panel.
Before you print:
•
Make sure that the Fiery ES has an Internet connection and is connected to the network.
•
Turn on PrintMe and related settings on the Fiery ES using Configure.
For information about configuring the settings in Setup on the Fiery ES, see Configuration and Setup.
•
Upload the document to PrintMe, either at http://www.printme.com or send by email to print@printme.com.
For more information about using PrintMe, see EFI PrintMe Cloud Service.
•
Print directly from a Windows application. To do this, you must first install the PrintMe printer driver. See
Install the PrintMe printer driver on page 59.
•
When you upload or email a document to PrintMe, you receive an email confirmation that contains a unique
document ID. You need this document ID to print, as described in the following procedures.
•
Make sure that the printer is not printing or processing any files.
•
PrintMe supports the following file types: PDF, XLS, DOC, PPT, GIF, JPG, TIFF, PICT, HTML, TXT, and PS.
The maximum file size is 25MB.
Note: The Enable Native Document Conversion Using PrintMe option in Configure must be turned on to print
DOC, PPT, and XLS files.
In particular, observe the following:
•
The PrintMe feature on the Fiery ES requires a subscription to the PrintMe Cloud Service.
•
For information or support related to the PrintMe Cloud Service, contact Electronics For Imaging at
printmesupport@efi.com.
•
PrintMe availability may vary, depending on the country or region.
Print a PrintMe document from a printer
You can print an uploaded document from the PrintMe Cloud Service to the printer.
1 On the printer control panel, press the Menu button.
2 Press Fiery.
3 Press PrintMe.
4 Type the Document ID and press Next.
Refer to the email confirmation for Document ID.
Jobs associated with the Document ID are displayed.
Printing
Other Printing Methods
58