Access Configure from WebTools
Use Configure to set up the Fiery ES. Setup is required the first time the Fiery ES is turned on or after system
software is installed. You also use Configure to specify information about the network environment and printing
preferences for jobs that users send to the Fiery ES.
1
Open an Internet browser and type the IP address of the Fiery ES.
2 In WebTools, click the Configure tab.
Note: If you receive a message about untrusted connections, you can ignore the message and proceed anyway.
3
Log on with Administrator privileges.
Configuration and Setup
Accessing the Fiery ES
24
To Next Page
Loading...
