Separate RGB/Lab to CMYK source
Select the Separate RGB/Lab to CMYK source option for RGB jobs to simulate an output printer other than the
printer to which you are printing.
For more information, see Color Printing.
Substitute colors
The Substitute colors print option, when selected, uses the substitute color values defined in Spot-On.
For more information, see Color Printing.
Image options
The Image tab shows all image quality settings supported by the connected Fiery ES and printer.
For information about options specified in Setup, see Configuration and Setup.
Brightness
The Brightness print option allows you to specify the image brightness for the print job.
Select 85% lightest for a substantially lighter image, 115% darkest for a substantially darker image, or one of the
settings in between.
Edge enhancement
When the Edge enhancement print option is set to On, it smooths the edges of text and graphics and reduces the
appearance of jagged edges.
Gloss print
Select the Gloss print check box to gloss the print job like a photograph.
This feature is available when the Paper type option is set to Plain paper and the Duplex option is set to Off.
Image enhance: Apply image enhancement
The Apply image enhancement option, when selected, applies photo enhancement to the job.
The supported file formats are PDF, PS, TIFF, and EPS.
This option is not valid for images under 72 dpi. Also, it is not applied to pages with a large number of images.
For more information, see Image Enhance on page 102.
Image enhance: Image enhancement range
Specify all pages, specific page(s), or sheets of the document to apply photo finishing enhancement.
Printing
Print Options
84
To Next Page
Loading...
