Select this option to overprint objects that are specified in the source PostScript or PDF file.
ImageViewer Curves
The ImageViewer Curves print option lets you apply color curve edits from ImageViewer that have been saved
on the server as a preset.
ImageViewer in Command WorkStation can be used to edit the CMYK curves of a job on the Fiery ES. These
curve edits can be saved as a preset and applied to other jobs. Use the ImageViewer Curves option to select a
preset for your job.
Factory-supplied curve edits apply some typical color corrections:
•
Lighter highlights
•
Midtone boost
•
No correction
•
Shadow detail
•
Reduce C (cyan) cast
•
Reduce M (magenta) cast
•
Reduce Y (yellow) cast
After the job is processed, the edits become part of the job and are no longer visible as edits when you view the
job in ImageViewer.
For more information, see Color Printing.
Optimize RGB transparency
You can use the Optimize RGB transparency option to achieve correct color output for areas of overlapping
transparent RGB or Lab colors (such as a drop shadow) in a PDF job.
Turn on to achieve correct color output for areas of overlapping transparent RGB or Lab colors (such as a drop
shadow) in a PDF job.
If you turn on Optimize RGB Transparency, the Fiery ES uses the correct RGB source profile and rendering intent
when converting the overlapping RGB colors to CMYK during the PDF-to-PostScript conversion. If you turn off
Optimize RGB Transparency, the area of overlapping colors might print with incorrect color or undesirable
artifacts.
This option is only accessible from the Job Properties window of Command WorkStation, Fiery Hot Folders,
and Virtual Printers. (See Color Printing).
Paper simulation
Select the Paper simulation check box to adjust the color according to the shade of the paper stock specified in
the selected CMYK/Grayscale source profile.
This option is available as part of Fiery Productivity Package. For more information, see Fiery Productivity
Package.
Printing
Print Options
83
To Next Page
Loading...
