Gangup layout options
Gangup layout options are used for speed printing imposition modes.
Note: The Gang-up feature is not valid if your job is sent to the Direct connection.
Gangup
Select Gangup to specify options for speed printing imposition modes.
Gang-up type
Gangup booklet has two types used for speed printing imposition: Step & repeat and Cut & stack.
Select Step & repeat to speed print a job by printing two document pages on each sheet. When the printed
sheets are cut in half, the result is two complete sets of the same document.
Select Cut & stack to speed print a job by printing two document pages side by side. When the printed sheets are
cut in half and stacked together, the result is one complete set of the document (in faster printing time).
For more information, see Gang-up printing on page 101.
Page Alignment: Duplex
The Page Alignment: Duplex print option allows you to select the duplex (double-sided) setting to specify the
orientation of printed images for gang-up printing.
Select Off for single-sided printing.
Specify Right & left binding for duplex (double-sided) printing to specify the orientation of printed images.
For more information, see Print Duplex (double-sided) pages on page 103.
Page Alignment: Increase gutter by
Increase gutter by controls the amount of space between adjacent pages on a sheet to adjust for trimming or
other finishing options.
You can specify the gutter value from -1.969 to 1.969 inch in 0.001 inch increments (-50.0 to 50.0 mm in 0.1 mm
increments).
Specify a positive value to increase the amount of blank space between adjacent pages.
Specify a negative value to decrease the amount of blank space between adjacent pages.
For more information, see Booklet Maker Help.
Printing
Print Options
73
To Next Page
Loading...
