EFI Fiery ES IC-418 - Page 22

2 In Command WorkStation, click the Server menu.
3
Select one of the following:
• Restart Fiery
Restarts the Fiery ES system software without rebooting the operating system on the Fiery ES.
• Reboot Server
Reboots the Fiery ES.
Shut down, restart, or reboot from the printer control panel
1
Make sure the Fiery ES is not receiving, processing, or printing any files. If the system has just finished
processing, wait at least five seconds after the system reaches Idle before you proceed.
2 On the printer control panel, press the Menu button. Press the Fiery logo and then press Tools.
3 Press Restart Server.
4
If prompted, log on as Administrator or Operator.
The default password is Fiery.1 (case-sensitive).
5
Select one of the following:
• Reboot Server
Completely restarts the Fiery ES, both the Fiery ES system software and the operating system software on the
Fiery ES.
• Restart Server
Restarts the Fiery ES system software without rebooting the operating system software on the Fiery ES.
• Shut Down System
Completely shuts down the Fiery ES.
Configuration and Setup
Integrating the Fiery ES into your network
22