5
Perform calibration, if needed.
If service has been performed on the printer since the last calibration, or calibration has not been performed,
perform calibration using the calibration set specified in the Postflight report.
6 Reprint the job, setting Postflight to Off.
Check the quality of an output profile
Use Postflight to check the quality of an output profile on the Fiery ES.
1 In your application, select File > Print, select the Fiery ES as your printer, and then go to the print options in the
printer properties.
2 On the Job Info tab, under Reporting, set Postflight to Test Page.
3 Click OK and print the job.
The Test page is printed.
4
Review the quality of the color on the Test page.
Note: Make sure that this page was printed with the same media and print option settings as the job.
5
Review the instructions on the Postflight Test Page.
6
Edit the color of the output profile, or create a profile, if needed.
It may be necessary to customize the output profile or create a new profile to get optimal results on the media the
job is using.
7 Reprint the job, setting Postflight to Off.
Diagnose color problem with a specific object
Use Postflight to diagnose a color problem with a specific object.
1 In your application, select File > Print, select the Fiery ES as your printer, and then go to the print options in the
printer properties.
2 On the Job Info tab, under Reporting, set Postflight to Color-Coded Pages.
3 Click OK and print the job.
The color-coded pages are printed.
4
Review the Postflight color-coded pages.
5
Make changes to the color settings, if needed.
Note: Use the Color-Coded Pages setting to send a job to another printer that has a specific color-space
requirement. For example, a document targeted to a CMYK-only printer must have only Cyan-colored objects.
6 Reprint the job, setting Postflight to Off.
Fiery Productivity Package
Postflight
19
To Next Page
Loading...
