Titanium Interfaces User Guide
pll_rule_output_name (error)
Message PLL output clock names have to be unique. Duplicates found: <list of string>
To fix You get this error when you use duplicate clock names. Rename them.
pll_rule_output_number (error)
Message Output number for <clk name> is invalid. It must be between 0 to <int>
To fix The output clocks are numbered (e.g., CLKOUT3). Make sure that the number is within
specified range.
pll_rule_param (error)
Message Invalid parameters configuration: <feature>
To fix Performs a general check for invalid parameters. Review the other error messages.
pll_rule_pll_freq (error)
Message
PLL Frequency is out of range, Freq=<value> Min=<min>MHz
Max=<max>MHz
To fix The maximum post-divided VCO clock fmax is 4,000 Mhz. Change the PLL clock calculator
settings so that it is in range.
pll_rule_post_divider (error)
Message Post-divider is invalid. Valid values are <list of int>
To fix Choose a post divider value from the list shown.
pll_rule_pre_divider (error)
Message Pre-divider is out of range. Min=<int> Max=<int>
To fix The pre-divider frequency needs to be within the range specified. Adjust the parameters to
meet that requirement.
www.efinixinc.com 129
To Next Page
Loading...