Endress+Hauser PROline promag 53 - Accessories; 8.1 Device-Specific Accessories; 8.2 Measuring Principle-Specific Accessories

Accessories Promag 53 PROFIBUS DP/PA
128 Endress+Hauser
8 Accessories
Various accessories, which can be ordered separately from Endress+Hauser, are available for
the transmitter and the sensor. The Endress+Hauser service organization can provide
detailed information on the order code of your choice.
8.1 Device-specific accessories
8.2 Measuring principle-specific accessories
Accessory Description Order code
Promag 53 transmitter Transmitter for replacement or for stock. Use the
order code to define the following specifications:
–Approvals
– Degree of protection / version
– Cable type for the remote version
–Cable entries
– Display / power supply / operation
–Software
– Outputs / inputs
53XXX - XXXXX * * * * * * * *
Conversion kit for inputs/
outputs
(PROFIBUS DP only)
Conversion kit with appropriate slot modules for
converting the present input/output configuration to
a new version.
DKUI - * *
Software packages for
Promag 53
(PROFIBUS DP only)
Software add-ons on F-CHIP, can be ordered
individually:
– Electrode Cleaning Circuitry (ECC)
–Batching
DK5SO - *
Accessory Description Order code
Mounting kit for
Promag 53 transmitter
Mounting kit for wall-mounted housing (remote
version). Suitable for:
•Wall mounting
•Pipe mounting
•Panel mounting
Mounting set for aluminum housings. Suitable for:
•Pipe mounting
DK5WM - *
Cable for remote version Coil and signal cables, various lengths. Reinforced
cable on request.
DK5CA - * *
Ground cable for
Promag E/L/P/W
A set consists of two ground cables. DK5GC - * * *
Ground disk for
Promag E/L/P/W
Ground disk for potential matching DK5GD * * *
Mounting kit for Promag H Mounting kit for Promag H, comprising:
– 2 process connections
–Screws
–Seals
DKH * * - * * * *
Adapter connection for
Promag A, H
Adapter connections for installing Promag 53 H
instead of Promag 30/33 A or Promag 30/33 H DN
25.
DK5HA - * * * * * *
Ground rings for Promag H If the process connections are made of PVC or PVDF,
ground rings are necessary to ensure that potential is
matched. A set comprises 2 ground rings.
DK5HR - * * * *
Set of seals for Promag H For regular replacement of the seals of the Promag H
sensor.
DK5HS - * * *
Wall-mounting kit for
Promag H
Wall-mounting kit for the Promag H sensor. DK5HM - * *
Welding jig for Promag H Weld nipples as process connection:
Welding jig for installation in pipes.
DK5HW - * * *