Promag 53 PROFIBUS DP/PA Identification
Endress+Hauser 9
2.2 Certificates and approvals
The devices are designed in accordance with good engineering practice to meet state-of-
the-art safety requirements, have been tested, and left the factory in a condition in which
they are safe to operate. The devices comply with the applicable standards and regulations
in accordance with EN 61010-1 "Protection Measures for Electrical Equipment for
Measurement, Control, Regulation and Laboratory Procedures" and with the EMC
requirements of IEC/EN 61326.
The measuring system described in this Operating Manual is therefore in conformity with
the statutory requirements of the EC Directives. Endress+Hauser confirms successful testing
of the device by affixing to it the CE mark.
The measuring system is in conformity with the EMC requirements of the "Australian
Communications and Media Authority (ACMA)".
The flowmeter has successfully passed all the test procedures carried out and is certified and
registered by the PNO (PROFIBUS User Organization).
The device thus meets all the requirements of the following specifications:
• Certified to PROFIBUS Specification Profile 3.0 version
(Device certification number: provided upon request)
• The measuring device can also be operated with certified devices of other manufacturers
(interoperability).
2.3 Registered trademarks
TRI-CLAMP®
Registered trademark of Ladish & Co., Inc., Kenosha, USA
KALREZ® and VITON®
Registered trademarks of E.I. Du Pont de Nemours & Co., Wilmington, USA
PROFIBUS®
Registered trademark of the PROFIBUS User Organization, Karlsruhe, D
HistoROM™, S-DAT®, T-DAT™, F-CHIP®, Field Xpert™, FieldCare®, Fieldcheck®,
Applicator®
Registered or registration-pending trademarks of Endress+Hauser Flowtec AG, Reinach, CH
To Next Page
Loading...
