Promag 53 PROFIBUS DP/PA Troubleshooting
Endress+Hauser 155
9.7 Return
"
Caution!
Do not return a measuring device if you are not absolutely certain that all traces of hazardous
substances have been removed, e.g. substances which have penetrated crevices or diffused
through plastic.
Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be
charged to the owner-operator.
The following steps must be taken before returning a flow measuring device to
Endress+Hauser, e.g. for repair or calibration:
• Always enclose a duly completed "Declaration of contamination" form. Only then can
Endress+Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EC REACH Regulation No. 1907/2006.
• Remove all residues. Pay special attention to the grooves for seals and crevices which could
contain residues. This is particularly important if the substance is hazardous to health, e.g.
flammable, toxic, caustic, carcinogenic, etc.
!
Note!
You will find a preprinted "Declaration of contamination" form at the back of these Operating
Instructions.
9.8 Disposal
Observe the regulations applicable in your country!
9.9 SoftwareHistory
Date Software version Changes to software Operating Manual
12.2009 PROFIBUS DP/PA
3.04.XX
Introduction of Calf history 71108007/12.09
08.2007 PROFIBUS PA
3.04.XX
Introduction of a new PROFIBUS PA I/O board 71060107/08.07
07.2007 PROFIBUS DP
3.04.XX
Software adjustment
10.2006 PROFIBUS DP
3.04.00
Software adjustment
12.2005
10.2005 PROFIBUS DP
3.01.XX
Introduction of a new
PROFIBUS DP I/O-board:
– Support of additional output signals
(current, frequency etc.)
Software expASMEon:
–Batching
50099246/10.05
To Next Page
Loading...
