Promag 53 PROFIBUS DP/PA Commissioning
Endress+Hauser 93
6.3.4 Quick Setup "Communication"
To establish cyclic data transfer, various arrangements between the PROFIBUS master (Class
1) and the measuring device (slave) are required which have to be taken into consideration
when configuring various functions. These functions can be configured quickly and easily by
means of the "Communication" Quick Setup. The following table explains the parameter
configuration options in more detail.
a0002600-en
Fig. 59: Quick Setup "Communication"
+
+
E
+
E
B
Quick SetupQuick Setup
6101
6140
6141
1006
Esc
E
+
-
XXX.XXX.XX
HOME-POSITION
Fieldbus Address
Selection
GSD
Unit To Bus
Setup
Communication
Quick Setup "Communication"
HOME position
F
MEASURAND (A)
O
QUICK SETUP (B)
N
QUICK SETUP
COMMUNICATION (1006)
Function No. Function name Setting to be selected (
OS
)
(to the next function with
F
)
1006 QS-COMMUNICATION After confirmation (YES) by pressing
F
the subsequent
functions are called up in succession.
6101 FIELDBUS ADDRESS Enter the device address (permitted address range: 1 to 126)
Factory setting: 126
6140 SELECTION GSD Select the operating mode (the GSD file) which should be
used for cyclic data transmission with the PROFIBUS master.
Options:
MANUFACT. SPEC. The measuring device is operated with
complete device functionality.
MANUFACT V2.0 The measuring device is used as the
replacement for the previous Promag 33 model
(compatibility mode).
PROFILE-GSD The measuring device is operated in the
PROFIBUS Profile mode.
Factory setting:
MANUFACT. SPEC.
!
Note!
For PROFIBUS network configuration, make sure that the
right device master file (GSD file) of the measuring device is
used for the selected operating mode:→ 101
To Next Page
Loading...
