Endress+Hauser PROline promag 53 - Nameplate for Connections

Identification Promag 53 PROFIBUS DP/PA
8 Endress+Hauser
2.1.3 Nameplate for connections
a0004562
Fig. 3: Nameplate specifications for "Promag" transmitter connections (example)
1 Serial number
2 Possible configuration of current output
3 Possible configuration of relay contacts
4 Terminal assignment, cable for power supply: 85 to 260 V AC, 20 to 55 V AC, 16 to 62 V DC
Terminal No. 1: L1 for AC, L+ for DC
Terminal No. 2: N for AC, L- for DC
5 Pending signals at the inputs and outputs
possible configurations and terminal assignment
6 Version of device software currently installed (inclusive language group)
7 Installed communication type
8PROFIBUS ID No.
9 Date of installation
10 Current updates to data specified in points 6 to 9
26(+) / 27(-)
NC:
Versorgung/
Tension d'alimentation
Observer manuel d'instruction
See operatingmanual
Betriebsanleitung beachten
Communication:
Drivers:
Device SW:
ID XXXX (HEX)
XX.XX.XX
PROFIBUS DP
PROFIBUS DP Profile 3.0()
12345678912Ser.No.:
Supply /
24(+) / 25(-)
22(+) / 23(-)
20(+) / 21(-)
N/L-
PE
A:
NO:
P:
L1/L+
12
319475-00XX
X
active
passive
normally opencontact
normally closed contact
Date: DD. MMM. YYYY
Update 1
Ex-works / ab-Werk / réglages usine
Update 2
(WEA)
1
4
5
6
7
8
9
2
3
P
NO
NC
max. 30 VAC / 0.5 A
max. 60 VDC / 0.1 A
max. 30 VAC / 0.5 A
3...30 VDC, Ri = 3 kOhm
max. 60 VDC / 0.1 A
STATUS–IN
RELAY
RELAY
27 = A (RxD/TxD-N)
26 = B (RxD/TxD-P)