Endress+Hauser PROline promag 53 - Performing the Pulsating Flow Quick Setup

Commissioning Promag 53 PROFIBUS DP/PA
88 Endress+Hauser
Performing the "Pulsating Flow" Quick Setup
This Quick Setup menu guides you systematically through the setup procedure for all the
device functions that have to be modified and configured for measuring pulsating flows.
Note that this has no effect on values configured beforehand, such as measuring range,
current range or full scale value.
a0004615-en
Fig. 57: Quick Setup for measuring severely pulsating flows. Recommended settings see next page
!
Note!
• The display returns to the cell QUICK SETUP PULSATING FLOW (1003) if you press the
Q
key combination during parameter interrogation.
• You can call up the Setup menu either directly from the "COMMISSIONING" Quick Setup
menu or manually by means of the function QUICK SETUP PULSATING FLOW (1003).
+
+
E
+
E
4200
4225
8005
6400
6402
6403
6404
4206
4208
4004
4005
B
2002
1003
Esc
E
+
-
XXX.XXX.XX
Yes No
Current output 1 Freq.-/Pulse output 1
Selection of output type
Quit
Frequency Pulse
Operation mode
Measuring mode
Alarm delay
Assign
LF-Cut off
On-value
LF-Cut off
Off-value
LF-Cut off
Pressure
shock suppression
Quit
Quick Setup
Measuring mode
Time constant
Measuring mode
Time constant
Quick Setup
HOME-POSITION
Display
damping
Pulsating flow
Configure another output ?
➁
➀
m
Only the output not yet configured in the current Setup is offered for selection in the second cycle.
n
The "YES" option remains visible until both outputs have been configured. "NO" is the only option displayed
when no further outputs are available.