Endress+Hauser Proline Prosonic Flow P 500 - Page 102

Commissioning Proline Prosonic Flow P 500 HART
102 Endress+Hauser
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Pipe wall thickness – Enter the pipe wall thickness. Positive floating
point number
3 mm
Liner material – Select liner material. • None
• Cement
• Rubber
• Epoxy resin
• Unknown liner
material
None
Liner sound velocity The Unknown liner material
option is selected in the Liner
material parameter.
Define the sound velocity of
liner material.
800.0 to 3 800.0 m/s 2 400.0 m/s
Liner thickness – Define the thickness of liner. 0 to 100 mm 0 mm
Sensor type – Select sensor type. • C-030-A
• C-050-A
• C-100-A
• C-100-B
• C-100-C
• C-200-A
• C-200-B
• C-200-C
• C-500-A
• CH-050-A
*
• CH-100-A
*
As per order
Sensor coupling The following option is
selected in Sensor type
parameter:
• C-030-A
• C-050-A
• C-100-A
• C-100-B
• C-100-C
• C-200-A
• C-200-B
• C-200-C
• C-500-A
Select coupling medium. • Coupling pad
• Coupling paste
Coupling pad
Mounting type – Select how the sensors are
arranged to each other.
• (1) direct option: sensor
arrangement with 1 traverse
• (2) V-mounting option:
sensor arrangement with 2
traverses
• (3) Z-Mounting option:
sensor arrangement with 3
traverses
• (4) W-mounting option:
sensor arrangement with 4
traverses
• (1) direct
• (2) V-mounting
• (3) Z-Mounting
• (4) W-mounting
• Automatic
Automatic
Cable length – Enter length of sensor cables. 0 to 200 000 mm As per order
FlowDC inlet configuration The 1 measuring point - 2
signal paths option is selected
in the Measuring point
configuration parameter.
Select FlowDC inlet
configuration.
• Off
• Single elbow
• Double elbow
• Double elbow 3D
• 45° bend
• 2 x 45° bend
• Concentric
diameter change
• Other
*
Off