165
Chapter3 Handling
Printing from the First Label (Auto cutter model only)
If the [Media Detect] setting has been set to [Gap], you cannot print on the first label (printed from the second
label) at the first time printing after loading paper.
However, for the auto cutter model, even when [Gap] is selected as [Media Detect], you can prevent missing of
the first label by following the procedure below.
1
Cut off the backing paper from 2 mm away from the top edge of the first label.
2
On the operation panel of the printer, select [Not Feed] from [Actions when Replac-
ing Media].
[Menu] - [General Settings] - [Printer Settings] - [Print Options] - [Actions when Replacing Media] -
[Not Feed]
The default setting is [Feed].
3
Specify a length of the label, and a gap between labels.
("Media Settings" on page 44)
4
Load paper, and then print.
For the paper loading procedure, see "Loading Paper" on page 45.
CAUTION
• When you perform the following and print, auto cut is disabled.
• If there is a difference between a label actually used and the settings on the printer driver, the
print quality may decline.
• For the peeler model, there is no measure to print from the first label.
• For the auto cutter model, this procedure is not necessary if [Media Detect] is [Black Mark] or [None].
Paper feed direction
2 mm
Label
(first)
Label
To Next Page
Loading...
Need help?
General
