210
Chapter4 Information for Application Development
For Ethernet Interface
Setting the IP Address
Set the IP address of the printer.
For the setting procedure, see "How to Configure the Network Settings" on page 42.
Configuring the Printer Resolution and Setting to Monochrome Print Mode
Using PrinterSetting, change the resolution of the printer to the resolution of the old printer.
Then enable the monochrome print mode. For the setting procedure, see "Replace settings from printer using
ZPL II comma
nds" on page 136.
Registering Your Background Image
Register your background image using PrinterSetting.
Registering the image
Set the image to be used as background image. See "Store data in the printer" on page 122.
Setting background image
Configure the background image settings. For the setting procedure, see "Background image settings" on page
123.
To Next Page
Loading...
Need help?
General
