45
Chapter2 Setup
Loading Paper
This section describes how to load and replace paper. As shown below, the procedure of replacing paper differs
depending on the size and whether paper has been/is going to be supplied from inside or outside.
Videos that show the procedure are also available.
Click the URL below to view the videos.
<https://support.epson.net/p_doc/790/>
Supply from Inside (Internal)
Paper is supplied from inside the printer. Set roll paper
attached to the spindle into the printer.
Supply from Outside (Rear Feed)
Paper is supplied from outside the printer. Place roll paper
or fanfold paper behind the printer.
c
IMPORTANT
When replacing paper with a different shape, form, or type of paper, change the paper settings either
from the operation panel or on the printer driver before loading the paper. ("Operation Panel
Sett
ings" on page 145, "Paper Source and Paper Detection Settings" on page 68, "User-Defined
Paper" on page 70)
Models Supply from Inside (Internal) Supply from Outside (Rear Feed)
Auto cutter model • Paper loading: Page 46
• Paper removal: Page
59
• Paper ejection at paper end: Page
62
• Paper loading: Page 50
• Paper removal: Page 59
• Paper ejection at paper end: Pa
ge 62
Peeler model • Paper
loading: Page 54
• Paper removal: Page
60
• Paper ejection at paper end: Page
63
To Next Page
Loading...
Need help?
General
