192
Chapter3 Handling
Paper is Fed and
Ejected
, and an Error
Occurs
Media Form:
Continuous Label
(BlackMark), Die-cut
Label (BlackMark)
The paper being used dif-
fers from that of Media
detection settings.
Check the paper being used and Media detection settings of the
printer. ("Paper Source and Paper Detection Settings" on page 68)
Th
e b
lack marks do not
comply with the specifica-
tions.
If the reflectivity of the black marks is higher than the specified
value, the black marks may not be recognizable. Infrared light is
used for black mark detection, and the infrared reflectivity needs
to be the specified value or lower.
Check the specifications of black mark printing, and use black
marks that comply with the printer specifications.
The black marks may become recognizable by adjusting the black
mark detector.
On the operation panel, select [Menu] - [Maintenance] - [Calibra-
tion] - [Simple Media Detect] in that order. If the problem is not
resolved, carry out [Media Detect].
The sensor has failed. If operation was normal up until now, the sensor has probably
failed. Request repairs.
Status Cause Solution
To Next Page
Loading...
Need help?
General
