227
Appendix
*1: If the gap is 3 mm or less, you need to adjust the detector.
• Paper with holes or cutouts cannot be used.
• Auto cutting on the perforated lines will generate scraps of paper that may cause problems. Also,
auto cutting ahead of the perforated line may cause problems when feeding paper. Therefore, per-
form auto cutting when paper is fed at least 0.8 mm away from the perforated line.
• Set the black mark position to a position at least 1. 5 mm away from the perforated line.
• Set the cut position to a position at least 0.7 mm away from the print start position on the next label.
To Next Page
Loading...
Need help?
General
